1. When unpacking the lamp, please remove the two black adjustable straps that hold the carrying handle, but do not remove the third black adjustable strap located near the cable. This strap secures the lower ring of the floor lamp and ensures the strength and stability of the base.

2. When taking the lampshade out of the tube, please do it carefully and evenly to prevent it from twisting in a spiral. Twisting may cause bends or marks on the plastic. There is also a high risk that the snap buttons could press against the edge of the plastic and leave dents. Assemble the lampshade only in the same direction in which it was rolled inside the tube - otherwise, some buttons may not fasten properly, and if forced, the shade could deform.

3. When lifting the floor lamp body (tube) upwards, make sure to first place one foot on the black adjustable strap that connects the two tubes near the cable (see point 1) and the other foot on the opposite side of the base (as shown in the video instruction). This step is very important to keep the base steady and flat on the floor. Only then should you begin raising the tube of the floor lamp and shaping the lamp as you wish.

4. The minimum bending diameter of the tube is 13 inches (33 cm). Please bend the tube carefully and slowly, distributing the force evenly along its entire length rather than applying pressure to a single point - otherwise, localized pressure may cause a crease (break) in the tube. Bend the tube only by holding it with both hands, do not grab the lamp holder or the collet near the cable to avoid damaging them.

5. We are not responsible for any consequences resulting from failure to follow the above instructions.If you experience any difficulties, have questions, suggestions for improving the product or collaboration, please contact us: artbuzukraine@gmail.com

With best regards,
«ARTBUZ» creative workshop team